Starter System
Everything for one electronic target: five sensor pods plus a spare, the target hub, the firing-line relay that runs the app on your phone, and the bases that hold it all on a coroplast backer.
In the box
- Target hub with battery and 915 MHz antenna
- Firing-line relay with battery and antenna
- 6 sensor pods (5 + 1 spare) with magnetic backs
- 6 sensor cables, 6 ft
- 8 backer bases: 3 bottom corner, 3 top corner with slide-in pod plate, 2 bottom centre (5 per target + spares)
- Roll of foam tape for coroplast, tape measure, USB-C charger and cables
- Waterproof hard case with custom foam for every part
You supply: two wooden stakes and a phone or tablet. Backer and targets are sold separately so you can pick your size.
Complete your setup
Specifications
| Detection | Supersonic shockwave, 5 MEMS microphones |
|---|---|
| Bullet speed at the target | Supersonic (above about 1,150 fps) |
| Radio | 915 MHz LoRa, target to relay |
| App | Any phone or tablet browser on the relay's WiFi, or the free Android app |
| Targets per relay | Up to 10 |
| Target sizes | 12, 18, 24 and 36 in (backer 2 in bigger) |
| Targets | Cardboard with square corners, up to 3 mm thick |
Questions
Does it work for pistols or subsonic loads?
No. It listens for the shockwave, so the bullet must still be supersonic when it reaches the target.
Can several shooters use one target?
Yes. On a grid target each shooter claims squares on their own phone and sees only their shots.
Can I use my own targets?
Yes. Staple or tape your paper target onto a blank cardboard target or onto the backer inside the five bases. The sensor positions don't change.
What if a pod gets hit?
With five sensors the target keeps working with one out, and the spare pod clips on in seconds.
How do I set it up in the app?
Enter your target size as the sensor spacing (a 24 in target is 24 in), tap Fill, and shoot. Full steps come on the quick-start card.